#Ravin lumenok how to
#Ravin lumenok free

Slip that on your lighted nocks and squeeze the base of the slit. Take an unused rubber fuel line about half a quarter and cut a slit 2 inches back there. But some of us use the wrong pliers and even pull them out with our teeth. Turning off Ravin Lumenok is not very difficult. And the Lumenok is turned off!! How Do You Turn Off Ravin Lumenok? Once you are done with the screws now pull the nocks with your hand a bit. Don’t overdo it as it can damage both the arrow end and Lumenoks. If the screws are too hard to move then hold the Lumenok side tight and twist the arrow carefully. Now take the arrow and lose the nock screws with your hand.

#Ravin lumenok free

It’s a bit tricky to turn off Lumenoks with a free hand. Step3:Īfter a few tries, you will see a little gap there. Wriggle it until there is a gap between the nock point and the Lumenok. Keep an eye on the Lumenoks if they create a gap. Once the nock is in place, now wriggle the arrow a couple of times. If so then use your hand and push it against the hand forcefully. Sometimes after you release the arrow the nock gets a bit displaced. Take your Lumenok inserted arrow and check the ends. Here is the systematic way to turn off my Lumenoks without using any extra tool- Step1: You can also remove the Lumenoks batteries to increase the battery life. Pull out both the nocks and shaft completely from the arrow and the Lumenoks are shut down easily. You can use other arrow pullers but I prefer Lumenoks extinguishers in this case.īut in case you want to shut off a Lumenok you need an extinguisher or arrow puller. You’ll need approximately 40-50 pounds of force to do it. Once there is enough of a gap present grab the extinguisher tightly.Īnd pull out the nocks slightly. This time don’t hold the extinguisher too tightly. Now wriggle it very carefully a few times. If Lumenoks are already a bit displaced and you see any gap then simply grab the nock with the tip of the extinguisher. You can buy extinguishers from amazon and Lumenok’s official website.

And the ends, if they are already a bit, are pulled out. So bring a Lumenok extinguisher arrow puller for this. The quickest way to turn off your Lumenok is to use an extinguisher. How Do You Turn Off Lumenok? (Step By Step) Based on different models Lumenok can light up to 40 hours and make a lot of long distances at night. There need no magnets to activate it and we can follow the way of our arrow. The force created through this release makes it work. It generally gets activated when we release the arrows. Lumenok is the tool that we use to recognize shot placement.

#Ravin lumenok how to

How To Turn Off Lumenok Without A Tool?.How Do You Turn Off Lumenok? (Step By Step).This is just a glimpse of the topic, and it’s a whole lot deeper than that. But turning it off with a hand is a bit difficult while using a tool is tricky. You can do it free-handed or with a toll. How to turn off Lumenok? Turning off a Lumenok needs a sight to pull out of the nocks. So, what’s that secret sauce? report this ad It took repeated practice until I learned the right way to turn off Lumenok. Over time, I figured it out and I’m now pretty fast to turn it off. When I heard Lumenok is better than nocturnal nocks, I switched to it however, after that, I discovered it’s a little trickier to turn off Lumenok.